The Electrical Installation Technician Course is designed to equip individuals with the knowledge and skills needed to install, maintain, and repair electrical systems in residential, commercial, and industrial settings. The course covers the fundamentals of electrical wiring, circuit design, safety procedures, and troubleshooting techniques. Students will learn how to work with electrical components such as transformers, motors, and generators, and will also be trained in the use of specialized tools and equipment used in the field. Graduates of this course will be prepared to pursue careers as electrical installation technicians, electricians, and other related fields.

• Workplace Safety for Electrical Installation ​

• Electrical Safety Rules and Regulation

• How to use Modernize Electrical Hand tools & Equipment ​

• Ohm’s Law applying ​

• Wiring Installation (Trunking Type) ​

• Wiring Installation (Conduit Type) ​

• Single Phase Energy Meter (kWh) Installation ​

• Consumer Unit (CU) Installation ​

• Switches Installation such as Key Card, PIR Sensors, etc. ​

• Sockets Installation such as 13 A, 15 A combination with Earth

• Three Phase and Single-Phase Installation ​

• PVC Conduit Pipe Bending ​

• Electrical Problems & Faults Testing

• Panel Board Installation with 4 pole MCCB, 4 & 2 pole MCB, 4 & 2 pole RCCB, 2 pole ELCB and 1 pole MCB with their ratings

• AC Voltmeter & Ammeter Installation ​

• Power Factor Meter Installation ​

• Emergency Switch, Push Button (PB) Installation ​

• Industrial Motors Control such as

• Direct Online Motor Control ​

• Forward/Reversed Motor Control Installation ​

• Star-Delta Starter Motor Control Installation ​

• Simple Sequence Control Installation ​

• Automatic Repetitive Sequence Order Control Installation ​

• Multiple Push Button Stations Starter Control Installation​

• Competency Standard

• Industrial Machines Control with PLC (Logo 8! PLC) such as ​

• Direct Online Motor Control ​

• Forward/Reversed Motor Control Installation & Programming

• Star-Delta Starter Motor Control Installation & Programming ​

• Simple Sequence Control Installation & Programming ​

• Automatic Repetitive Sequence Order Control Installation & Programming ​

• Multiple Push Button Stations Starter Control Installation & Programming

• Traffic Light Control Installation and Programming

• PLC (Logo 8! SIEMENS) ကို Hardware & Software (Logo 8.3) ​

• Electrical Installation with KNX linking PLC

• KNX ETS (6.0.6) Software Installation ​

• KNX Hardware Installation such KNX Switches (ON/OFF) ​

• KNX Power Supply Installation ​

• IP Line Coupler Installation ​

• KNX IP Communication Module Installation ​

• KNX IP Router Installation ​

• KNX Motion Sensor Installation ​

• KNX Touch Sensor Installation ​

• KNX Dimmer Installation ​

• KNX ON/OFF KNX controller 4 x 16 A outputs Modules Installation ​

• KNX Shutter Actuator Installation

• KNX BUS/Cable Installation and Data Flow Check, etc. ​

• It can be said that KNX is a kind of modern electrical design software which is a Belgian brand. As the times progress, there is a need for proper installation and control in electrical installations as well. Therefore, KNX and PLC (Logo 8!) are linked and electrical appliances are installed according to the times. So, we will teach you until you understand KNX and use both KNX Hardware & Software (ETS 6.0.6) well. ​